The following boot image information is in this document: This document is intended to give the reader an indication of which port adapters are supported in the standard 12.0 S boot image.
It is supported in Cisco IOS Release 12.0 (22) S and later releases of 12.0 S, although PA-A3-8T1IMA and PA-A3-8E1IMA are not supported. The c7200-kboot-mz image is supported in some Cisco IOS releases, such as E and T. See Table 8 for information on using other devices from which to boot. Using newer port adapters-that require the c7200-kboot-mz image-with older I/O controllers that use the standard boot image, can result in a system that is unable to boot from a network (TFTP) server. The sections and tables in this document provide information about which I/O controllers, port adapters, and service adapters are supported by each boot image.Ĭaution Check both the I/O controller requirements as well as the port adapter requirements to determine if the port adapter is supported on a boot image. See the 'c7200-mboot-mz Image Information' section. The c7200-mboot-mz image is supported on later releases of 12.0(32)S2 also. The c7200-mboot-mz image is small enough to fit on older I/O controller Flash (bootflash) memory. The c7200-mboot-mz image was released in April, 2006 on Cisco IOS Release 12.0(32)S2 and contains support for a small, specific set of port adapters and older I/O controllers.
The c7200-kboot-mz image is too large to fit in the Flash (bootflash) memory of the older I/O controllers and cannot stored on them however the image can be used if stored on an external flash device and the router is configured with the boot bootldr : configuration command.
The c7200-kboot-mz image was released in October, 2000 and is larger than the standard c7200-boot-mz image because it supports newer hardware that is not supported in the c7200-boot-mz image. The three images are the standard c7200-boot-mz boot image, the c7200-kboot-mz boot image, and the c7200-mboot-mz image.
Gns3 router images download series#
The Cisco 7200 series routers have three basic boot images that support different hardware options.
Gns3 router images download software#
Adding Cisco 7201 and PA-T3/E3-EC information.Īdding PA-MC-T3-EC information, and additional NPE-G1 and NPE-G2 information.Īdding VPN Service Adapter information, clarifying VAM support, older I/O controller with newer port adapter information, and clarification of software releases.Īdding NPE-G2 and its new boot image information.Īdding Cisco IOS Release 12.0 (22) S kboot information and Cisco IOS Release 12.0(32)S2 c7200-mboot-mz information.Īdding PA-POS-1OC3 and SA-VAM2+ information.
0 kommentar(er)
